User manual
41
Start-up
To integrate the floor heating actuator into your system and enable it to
communicate with other devices, you must teach it in first.
You can either pair the floor heating actuator directly with other Homemat-
ic IP devices (e.g. the wall thermostat or the Multi IO Box) or teach it in to
the Homematic IP Access Point. After pairing, the device is configured at
the wall thermostat. After teaching-in to the Access Point, the device is
configured via the Homematic IP app.
6.4.1 Pairing with a Homematic IP Wall Thermostat
Please make sure you maintain a distance of at least 50cm be-
tween the devices.
You can cancel the pairing procedure by briefly pressing the sys-
tem button (A) again. This will be indicated by the device LED (A)
lighting red.
If no pairing operations are carried out, pairing mode is exited
automatically after 3 seconds.
If you want to pair the floor heating actuator with a Homematic IP Wall
Thermostat, the pairing mode of both devices has to be activated first. To
do this, proceed as follows:
• Select the channel for pairing a device by pressing the select
button (B) briefly (see fig. 7). Press once for channel 1, twice for
channel 2 etc. The channel LED lights permanently for the cor-
responding channel.
• Press and hold down the system button (A) for 4 seconds un-