User manual

37
Start-up
• Use a pen to mark the positions of the two bore holes with a dis-
tance of 13.6 cm on the wall (see figure 3).
• Use an appropriate drill to make the holes as illustrated.
• Use the supplied screws and plugs to fasten the floor heating
actuator (see fig. 3).
5.2 DIN rail mount
For mounting the floor heating actuator to a DIN rail, please proceed as
follows:
• Place the floor heating actuator onto the DIN rail (see fig. 4).
• Latch the floor heating actuator by pressing the spring latches (E)
upwards (see fig. 4).
• Make sure that the spring latches are completely latched and that
the device is seated solidly on the rail.
6 Start-up
6.1 Installation instructions
Please read this entire section before starting to install the device.
Please note! Only to be installed by persons with the relevant
electro-technical knowledge and experience!*
Incorrect installation can put
• your own life at risk;
• and the lives of other users of the electrical system.