User manual

35
Replacing batteries
• Insert two new 1.5 V LR6/mignon/AA batteries
into the battery compartment (D), observing the
correct polarity as marked.
• Push the cover down onto the battery
compartment (D) and turn it clockwise until it
locks into place.
Once the battery has been inserted, the motion detector
will perform a self-test (approx. 2 seconds). Afterwards,
initialisation is carried out. The LED test display will
indicate that initialisation is complete by lighting up
orange and green (see sec. “9.2 Error codes and flashing
sequences” on page 37) .
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries
to excessive heat. Do not short-circuit batteries.
Doing so will present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.