User manual

Start-up

• Now drill the bore holes.

If you are working with a stone wall, drill the

marked 5 mm holes and insert the plugs supplied.

If you are working with a wooden wall, you can

pre-drill 1.5mm holes to make screws easier to

insert.

• Use the supplied screws and plugs (K) to fasten

the mounting plate to the wall (see ﬁgure 4).

• Attach the clip-on frame (A) to the mounting

plate.

• Place the remote control (B) back into the frame

(see ﬁgure 1). Make sure that “TOP” and the ar-

rows on the back side point upwards and that the

clips on the mounting plate latch into the open-

ings on the remote control.

5.2.3 Installation in multiple combinations

You can mount the wall-mount remote control with the

attachment frame (A) provided or use it with frames of

other manufacturers as well as integrate the remote con-

trol (B) into a multi-gang frame. You can ﬂexibly ﬁx the

mounting plate (F) to the wall using adhesive strips or

screws. For mounting with multiple combinations, make

sure that the mounting plate of the push button is seam-

lessly aligned to the already ﬁxed mounting plate/retain-

ing ring.