User manual

46
Troubleshooting
If the voltage drops too far during transmission, the
empty battery symbol ( ) and the corresponding er-
ror code will be displayed on the device (see „8.4 Error
codes and flashing sequences“ on page 47). In this
case, replace the empty batteries by two new batteries
(see „7 Replacing batteries“ on page 44).
8.2 Command not confirmed
If at least one receiver does not confirm a command, the
device LED lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
by radio interference (see „11 General information about
radio operation“ on page 50). This may be caused be
the following:
• Receiver cannot be reached.
• Receiver is unable to execute the command
(load failure, mechanical blockade, etc.).
• Receiver is defective.
8.3 Duty cycle
The duty cycle is a legally regulated limit of the transmis-
sion time of devices in the 868 MHz range. The aim of
this regulation is to safeguard the operation of all devices
working in the 868 MHz range.
In the 868 MHz frequency range we use, the maximum
transmission time of any device is 1% of an hour (i.e. 36
seconds in an hour). Devices must cease transmission
when they reach the 1% limit until this time restriction