Owner Manual

INSTALLATION
1. SHUT OFF SUPPLY
Shut off hot and cold water supply lines.
Clear Sink ledge of all debris.
2. POSITION FAUCET
Spread a small amount of tub and tile calk on the
surface of the bottom plate facing the counter or sink.
Position faucet through bottom plate, down through
holes of counter top or sink.
5. FLUSH LINES (IF NECESSARY IN NEW
CONSTRUCTION)
Remove aerator. Turn on water supply to faucet.
Flush lines by running both cold and hot water
through faucet in full open position for 15-20
seconds. Replace aerator (do not cross thread).
Check supply lines for leaks. If aerator ever
becomes clogged, repeat flushing.
6. CARTRIDGE
If the faucet develops a leak, it may be the result
of debris in the water line which is preventing a
good seal. Turn the faucet full on and off several
times to flush out any material that may be lodged
in the faucet. If the problem persists, follow these
steps:
Turn off the water supply. Open the faucet to relieve any line pressure. Remove
the handle by loosening the set screw. Remove the cartridge nut counterclockwise
with an 8" crescent wrench. Remove the cartridge by gently prying the cartridge
flange up with a small blade screwdriver. Remove rubber seat washer inside faucet
shank if necessary to remove debris. Replace all components in reverse order.
Turn water on and check for leaks.
Importer：
Company : KaiPingShi JiaDun WeiYu YouXianGongSi
Add : No. 38-5/7, Jin Long Lu, Jia Xing Gong Ye Qu
Shui Kou Zhen, Kai Ping
Email : [e-mail]
Manufacturer：
Company : HeShanShi Bai Sheng Jia Pin Chu Wei Ke Ji YouXianGongSi
Add : B Qu Dongxi Kai Fa Qu Zhi Shan Zhen He Shan City
Tel : [phone]
EU sales representative：
Company : Kong Hungary Üzlet KFT
Add : 1102 Budapest, Körösi Csoma Sádor út 9. 1. em. 4
3. TIGHTEN NUTS
Align faucet from underside of mounting surface and
secure by hand tightening locknuts. THE BOTTOM
PLATE MUST BE USED.
4. CONNECT WATER SUPPLY
Connect water supply:Hot water to the left and cold water
to the right. Make sure that the end of your existing supply
line is straight and will touch the chamfer on the inside of
the threaded shank. Screw the tailpiece nut onto the
faucet shank. Hand tighten.