Use and Care Manual

ManualsBrandsHomelite ManualsAccessories21 in. Surface Cleaner Attachment for Gas Pressure Washer

after tightening

securely,

nozzle opening should

be pointed

in same direction as

spray bar

nozzle opening

21 in. Surface Cleaner Attachment

AP31025

WARNING:

To reduce the risk of injury, user must read and under-

stand the operator’s manual for their pressure washer

before using this accessory. Fits most pressure wash-

ers. Ensure compatibility and proper fit before using this

accessory. Wear eye protection marked to comply with

Z87.1. Risk of fluid injections; do not point at people,

pets, electrical devices or the unit itself. Turn off the pres-

sure washer before changing or adjusting accessories.

For cold water use only. Save these instructions. Refer

to them frequently and use them to instruct other users.

If you loan someone this tool, loan them these instruc-

tions also.

PRODUCT SPECIFICATIONS

Connection ....................... 3/8 in. Quick Connect Plug Inlet

Maximum Pressure .......................................up to 4000 psi

Maximum Water Flow ...............................................4 GPM

Maximum Water Temperature ....................................180°F

ASSEMBLING THE SURFACE CLEANER

See Figure 1 - 4.

n Place the legs of the lower handle in the mounting brack-

ets on the surface cleaner deck. Align the holes in the

legs with the holes in the brackets.

n Insert pin through the holes in the mounting brackets and

legs. Install split-ring through hole on the end of the pin

to secure.

n Repeat this process to secure the other leg.

n Attach the top portion of the handle to the lower handle.

Secure with pin and split ring.

n Apply high strength threadlocker liquid (if needed) to the

ends of the hose.

n Attach the fixed end of the hose to the trigger handle inlet.

Securely tighten, but do not overtighten.

n Attach the swivel end of the hose to the inlet on the top

of the surface cleaning deck. Securely tighten, but do not

overtighten.

n Check the bottom of the surface cleaner deck to verify

that the nozzles are tightened securely and are aligned

correctly.

Fig. 1

Fig. 4

Fig. 2

Fig. 3

split ring

mounting

bracket

lower

handle

leg

upper

handle

lower

handle

split

ring

surface

cleaner

spray

trigger

inlet

plug

Summary of content (6 pages)

PAGE 1
21 in. Surface Cleaner Attachment ap31025 WARNING: To reduce the risk of injury, user must read and understand the operator’s manual for their pressure washer before using this accessory. Fits most pressure washers. Ensure compatibility and proper fit before using this accessory. Wear eye protection marked to comply with Z87.1. Risk of fluid injections; do not point at people, pets, electrical devices or the unit itself. Turn off the pressure washer before changing or adjusting accessories.
PAGE 2
WARNING: To reduce the risk of injection or injury, only use the surface cleaner on flat, horizontal surfaces. Never lift the surface cleaner from the cleaning surface while operating the pressure washer. using the SURFACE CLEANER See Figure 5. n Attach the high pressure hose of your pressure washer to the inlet plug on the surface cleaner’s trigger handle. n Connect the garden hose to your pressure washer and start the pressure washer as described in your pressure washer manual.
PAGE 3
Accessoire de 533 mm (21 po) pour nettoyeur de surface ap31025 AVERTISSEMENT : Pour réduire les risques de blessure, l’utilisateur doit lire et comprendre le manuel d’utilisation de sa laveuse à pression avant de l’utiliser. Convient à la plupart des laveuses à pression. S’assurer que l’accessoire est compatible et qu’il est bien installé avant de l’utiliser. Porter une protection oculaire certifiée conforme à la norme Z87.1.
PAGE 4
AVERTISSEMENT : Pour réduire le risque d’éclaboussures ou de blessures, utiliser uniquement le nettoyeur de surface sur une surface plane et horizontale. Toujours diriger le nettoyeur de surface sur la surface à nettoyer pendant l’utilisation de la laveuse à pression. UTILISATION DU NETOYEUR DE SURFACE Voir la figure 5. n Brancher le tuyau flexible haute pression de la laveuse à pression dans la prise d’entrée de la poignée à gâchette du nettoyeur de surface.
PAGE 5
Accesorio para limpiador de superficie de 533 mm (21 pulg.) ap31025 ADVERTENCIA: Para reducir el riesgo de lesiones, el usuario debe leer y comprender el manual del operador de la lavadora de presión antes de usar este accesorio. Para la mayoría de las lavadoras de presión. Antes de usar el accesorio, asegúrese de que sea compatible y se ajuste correctamente. Use protección ocular con la marca de cumplimiento de la norma ANSI Z87.1.
PAGE 6
ADVERTENCIA: Para reducir el riesgo de inyección o lesión, sólo utilice la unidad de limpieza sobre superficies planas y horizontales. Nunca levante la unidad de limpieza de la superficie de limpieza al utilizar la lavadora a presión. USO DEL LIMPIADOR DE SUPERFICIE Vea la figura 5. n Una la manguera de alta presión de la lavadora de presión a la clavija de entrada de la unidad que se encuentra en el mango del gatillo de la unidad de limpieza de superficies.