Installation Guide

Doc. ID: 268 Rev: 3 Effective: 9-18-2020 Page | 11
CARE AND MAINTENANCE GUIDE
Oil Finished Flooring
AFTER INSTALLATION:
WOCA Oil Refresher, available in Natural and White, should be used right after installation before the floor is exposed to daily foot traffic. Oil Refresher
combines efficient cleaning with oil rejuvenation, as additional oil penetrates the wood and forms a
protective layer in the surface.
Procedure:
1. Shake the bottle well before and during use.
2. The floor must be free of dust before treatment.
3. Mix Oil Refresher with lukewarm water in a ratio of 1:40 (3 oz. Refresher per gallon of water).
a. Mixing ratios can vary depending on wear and requirement.
b. We recommend using two buckets, one with Oil Refresher solution, the other with clean rinse water.
4. Mop a small section of floor with a lightly wrung cotton mop along the wood grain. Immediately afterwards, dip mop into Oil Refresher solution,
wring it hard and mop the area, again along the grain. Change rinse water often!
5. Leave the floor to dry for approx. 2 hours before use.
6. For slightly higher sheen, polish the dry floor with a white pad.
DAILY MAINTENANCE:
1. Sweep dust mop or vacuum your floor regularly to remove any particles that could cause abrasion or scratch your floor. CAUTION: Vacuums with a beater bar
or power rotary brush head can damage a floor and should never be used.
2. Use a damp mop to remove spots and soil. Apply appropriate cleaning solution to the cleaning cloth / mop. Do NOT apply directly to the floor.
3. Do
NOT leave any amount of liquids (water, juice, soft drinks, spills, etc.) on the floor. Clean any wet spots immediately.
4. Do
NOT use a steam cleaner.
5. Do
NOT use a wet mop or douse floor with water or liquid cleaners. Liquid can seep between the cracks and cause moisture damage.
6. Do
NOT use any cleaning agents containing wax, oil or polish. Left over residue will form a dull film.
7. Do
NOT use steel wool or scouring powder which will scratch the floor.
PREVENTATIVE MAINTENANCE:
• Protect your floor when using a dolly for moving furniture or appliances. Protective sheets and/or plywood may be needed. Never slide or roll heavy furniture
or appliances across the floor.
• Place protective pads beneath furniture legs and other heavy objects.
• Avoid excessive exposure to water from being tracked in during periods of inclement weather.
• Minimize abrasive material and dirt by placing mats on both sides of exterior doors and by using area rugs in high-traffic areas
• Rearrange furniture and rugs periodically to avoid uneven color and shade changes from light exposure.
• Use protective mats beneath rolling chairs and keep furniture casters clean.
• Keep pets’ nails trimmed.
• Remove shoes with cleats, spikes or exceptionally pointy heels before walking on the floor.
CLIMATE MAINTENANCE:
• Care should be taken to control humidity levels within the 35% - 55% range. Flooring, especially hardwood, dimensions will be affected by varying levels of
humidity.
• Dry Climates: A humidifier is recommended to maintain humidity levels. Wood stoves and electric heat tend to create very dry conditions during the winter
months this also will cause shrinkage in flooring.
• Humid, Wet Climates: By using an air conditioner, heater, or dehumidifier proper humidity levels can be maintained to prevent excessive expansion due to
high moisture content.