User Manual
6
Energy Conservation
• The cooler should be placed in a room that is dry and ventilated. The cooler cannot be placed under direct
sunlight or next to heat source (such as a radiator, stove, etc.), and a suitable insulation board must be applied
if necessary.
• Try to shorten opening time of cooler’s door.
• Avoid putting warm beverages in the cooler.
PROPER USE OF BEVERAGE COOLER
INTRODUCTION TO THE BEVERAGE COOLER’S FUNCTIONS
Display Controls
When turning on for the rst time, the display screen
will be a full display for 3 seconds and the startup
tone will ring.
Standby Mode
To activate standby mode, hold the standby button for
3 seconds. You will hear a beep and the display area
will be cut off. To deactivate standby mode, press the
button again. You will hear a beep and the standard
display will show.
Lighting
Press the lighting button to turn the light on or off.
Temperature Seing
Press the increase temperature button to increase the
temperature one degree at a time. Press the decrease
temperature button to decrease the temperature one
degree at a time.
Memory Function
If turned off, this cooler will remember any settings in
place and will work according to those settings once it’s
turned on again.
Fault Indicators
If any of these indicators are displayed it means the
cooler has the following issues.
E1 R Room sensor failure
R room defrost sensor failure
FAULT CODE DESCRIPTION
E4
Operation