Assembly Instructions

Table Of Contents

Page 1Page 8

Model: 155-A309-016-064

Setup and Operation Guide

Comfort Lift Chair

• NOTE: This device complies with part 15 of the FCC rules. Operation is subject to

the following two conditions: (1) this device may not cause interference, and (2) this

device must accept any interference, including interference that may cause undesired

operation of the device. Modications not approved by the party responsible for

compliance could void user's authority to operate the equipment.

-A309-016-064

PAGE 1
• NOTE: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Modifications not approved by the party responsible for compliance could void user's authority to operate the equipment.
PAGE 2
TABLE OF CONTENTS Important Safety Information .................................................................................3 Fabric Care...............................................................................................................4 Assembly Of Your Lift Chair Transformer and Cord Connections ......................................................................4 Attaching the Chair Back to the Chair Base .........................................................
PAGE 3
Page 6
PAGE 4
OPERATING YOUR LIFT CHAIR FABRIC CARE INSTRUCTIONS HEAT HEAT (On/Off) UP UP (Lift Chair) CORD AND TRANSFORMER CONNECTIONS UNLOCKED (LED) The transformer and the power cable are in a foam bag located on top of the chair. Connect to the plug coming from the seat. MASSAGE SETTINGS (LEDs) WAVE INTENSITY SETTINGS (LEDs) LOCKED (LED) DOW N DOWN (Lower Chair) STDY PULSE MASSAGE LO Connect the massage unit from the back to the plug marked BACK.