Installation Guide

2
www.homewerksww.com
PRODUCT SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS
Max. Flow Rate: 1.2 GPM (4.54 LPM) at 60 PSI Ceramic cartridges
ASME A112.18.1/CSA B125
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
NSF 61-9
Polished chrome, brushed nickel or oil rubbed bronze nish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
1
5.
Make Connections to
Water Lines:
Use 1/2 in. I.P.S. faucet connections
(2), or use supply line coupling nuts
(3) (not included) with a 3/8 in. O.D.
ball-nose riser (1). Before tightening
the faucet connector to the water
supply, apply a second wrench to
the supply tube tting. This will
prevent the supply tube from
moving or twisting when tightening
the faucet connector.
Do not overtighten.
3
2
1
5
2. Place the spout ssembly (1) through
the mounting hole in sink. Secure the
spout assembly (1) with the washers
(2) and nut (3).
NOTE: Ensure that the hole for the
lift rod faces toward the rear of the
sink during installation. When you
insert the lift rod, the lift rod can go
through the spout assembly (1) and
down into the slot of the washers (2).
1
2
3
2
6. Remove the stopper (1) and the
ange (2). Screw the nut (3) all the
way down, and push the gasket (4)
down.
1
2
4
3
6
3. Slide the hot and cold end valves
(1 & 2) through the sink mounting
holes. Make sure the long tubes are
installed away from the spout assembly
(3). Secure the end valves (1 & 2) with
the washers (4) and nuts (5). Hand
tighten the nuts (5) onto the end
valve (1 & 2) shanks. Lock the nuts
(5) into position by tightening the
screws (6) with a Phillips screwdriver.
NOTE: The hot side end valve is
labeled.
1
2
3
4
6
5
3
7. Apply silicone to the underside of
the ange (1). Insert the pop-up
body (2) into the sink. Screw the
ange (1) onto the pop-up body
(2). The pivot hole (3) must face
the back of the sink. Use the
groove joint pliers to tighten the
nut (4), but do not over tighten.
Do not turn the pop-up body (2)
while tightening the nut (4) or the
sealant may not seal properly.
Clean away any excess putty.
S
I
L
I
C
O
N
E
1
2
3
4
7
4. Align the tabs (1 & 2) on the quick
connect assembly (3). Push the quick
connect assembly (3) rmly upward
and snap it onto the receiving tube
tab. Pull down moderately to ensure
the connection has been made. If
it is necessary to remove the quick
connect assembly (3), squeeze the
tabs on the hose, and then pull down
to disconnect.
1
2
3
4
8. Remove the pivot nut (1). Install
the horizontal rod (2) and the
stopper (3), as shown (4). Hand
tighten the pivot nut (1). Attach the
horizontal rod (2) to the strap (5)
using the clip (6).
2
1
3
4
5
6
8