User Manual
9
The concentrator is suitable to remove dirt from hard-to-reach places, from corners, gaps, etc.
The close the concentrator is to the treated place, the greater the cleaning efciency will be
because the temperature and steam volume are at their highest at the steam output.
The concentrator can be combined with a round brush or angle nozzle to get better results.
Round brush
You can attach the round brush on the steam cleaner connector, exible hose connector, or
concentrator. Always ensure it is rmly attached.
The brush is used to remove stubborn dirt. Stubborn dirt can be removed more easily by
brushing.
Do not clean the sensitive or delicate surfaces by brush. They may be damaged.
Angle nozzle
You can attach the angle nozzle on the steam cleaner connector, exible hose connector, or
concentrator. Always ensure it is rmly attached.
The angle nozzle is used to remove dirt from hard-to-reach or narrow places, from corners, etc.
Brush nozzle
To attach the brush nozzle, align a white dot on the nozzle with a symbol of open lock on the
steam cleaner and turn the nozzle clockwise till the white dot is aligned with a symbol of closed
lock. Check the nozzle is correctly attached and it does not move.
The brush nozzle is used to remove dirt and dust from washable surfaces in the bathroom, to
clean mirrors, working desk in the kitchen, etc.
Attach the cloth on the brush nozzle to remove dirt and dust from sensitive surfaces, e.g., from
curtains or furniture, etc.
The cloth is washable so that you can re-use it. Pay attention when removing the cloth from the
nozzle after use as the cloth may be very hot.
Window wiper
Attach the window wiper to brush nozzle so that the protrusions at the bottom of the wiper t
to the openings at the bottom of the nozzle. And then attach the upper part of the wiper to the
nozzle until it clicks.
The window wiper is used to wipe steam and water from windows, glass door, or wall tiles.
Warning:
Always make sure the steam cleaner is switched off and unplugged when you attach or remove
the accessory. Before removing the accessory, wait at least 5 minutes to cool down. The
accessory becomes hot during use. There is a risk of injury or scalding from hot steam or water.
Never remove the accessory when the steam cleaner is used.
Filling the water tank
1. Place the steam cleaner on a at, dry, and stable surface.
2. Unscrew the safety cap anti-clockwise.
3. Insert the funnel in the tank neck and pour clean and cold water inside. The maximum
possible volume of the water tank is 250 ml. Use the supplied measuring cup to ll the water
tank.
4. Screw the safety cap clockwise and tighten rmly.
Note:
It is recommended to use distilled water, especially if you have very hard water. That will prevent
the formation of limescale. Always pour only the maximum volume into the water tank. More