Installation Guide

5
5
Attached the light fixture to the back plate using the center
mounting screw:
• Tighten the center mounting screw securely through the center of
the light fixture. Do not overtighten.
• Push the rubber plug firmly into the center hole to cover the center
mounting screw.
6
Using silicone caulking compound, caulk completely around where
the light fixture meets the wall surface to prevent water from
seeping into the outlet box.
Note: If you install this light fixture on the covered wall or eave
without junction box, you must
consult a qualified, licensed electrician and use the appropriate
screws (not included) to install this light fixture on the wall or eave
directly depending on the surface.