User's Manual

18 • Adding Computers to the Network
Click one of the Configure options. If your Internet connection
is DHCP (Dynamic Host Configuration Protocol), you do not
need to enter any further information. Go to step 5.
If you click the option for PPPoE Server or for Configure
Manually, type the information into the text boxes.
■ For the PPPoe (Point-to-Point Protocol over Ethernet)
server, type your ISP (Internet Service Provider) user
name and your password in the ISP Password and Confirm
ISP Password boxes.
■ For the Configure Manually option, you must type
numbers into all the text boxes that apply to your Internet
connection. The Internet settings (addresses) are
•IP Address - Internet Protocol address, which is the
number of a computer or device on the Internet
•Subnet Mask - a filter that determines the sub-network
that an IP address belongs to
•Default Gateway - the entry point of the network
•Primary and Secondary DNS - Domain Name System,
which translates domain names (such as
www.AirWaySystem.com) into IP addresses
Click Submit Changes.
TransPort is restarted, so you will lose connection to your network.
Shortly, the connection is re-established and the Network Status
page is displayed. It confirms the settings that you have made.
Repeat the installation of software for each of the computers on
your AirWay 11 Mbps Network. Remember that for the additional
computers of the network you do not need to configure the Internet
Gateway. At the end of installation, the Network Status page is
displayed confirming that the settings are correct and that the
network is operational.
3
4
5