User's Manual

10 • Installing TransPort
Installing TransPort
Setting up Your Network
Setting up the AirWay 11 Mbps Network consists of installing the
TransPort unit and then configuring the software for the computers
and TransPort. The procedure for the initial setup includes the
following steps:
1. Connect TransPort to the modem with the supplied cable and to
the power source.
2. Install a AirWay network card into the first client computer.
(This card is sold separately from TransPort.)
3. Install the software for the first client computer and configure
the settings for TransPort.
4. Install cards and the software for the remaining clients
computers of the WLAN.
This chapter and the next, “Adding Computers to the Network” on
page 13, describe this process.
Connecting TransPort
Record the TransPort serial number. You will need this
information during the software installation process, for
configuration purposes, and for support calls.
The serial number is located both on the label beneath the
cover and on the bottom of the unit. Refer to the accompanying
illustrations for information on removing the cover and
1