User's Manual

Installing Handsets • 31
35(/,0,1$5<Y
Handset installation sequence
Use the following steps to add a handset to
the network.
1. Attach protective rubber feet to charging
cradle (unless wall-mounting the cradle).
2. Install the battery pack.
3. Charge the handset.
4. Register the handset with the Controller.
Attaching rubber feet to charging cradle
If you are placing the handset charging
cradle on a desk or other horizontal surface,
attach the included protective rubber feet to
the underside of the cradle as shown in the
following illustration.
Note: If you are mounting the charging
cradle on a wall, refer to the wall-mounting
instructions at the end of this manual.