User's Manual

26 • Installing Data Jacks
35(/,0,1$5<Y
Jack. See page 13 for information on
installing the Controller.
• You must have an available 9-pin serial
port on your PC. Refer to your PC’s user
manual for information on serial ports.
Installation Procedure
Use the following steps to install the Data
Jack.
1. Complete the Installation Worksheet;
2. Connect the Data Jack;
3. Run the installation wizard included on
the driver diskette.
Note: The Data Jack driver software is
provided on a 3-1/2” diskette. If you need
a different media, contact HWN
Customer Service at 1-888-WHY-WIRE.
Installation
Worksheet
You will need to have the following
information handy in order to install the Data
Jack. Be sure to fill in all the blanks on the
worksheet before beginning the installation
process.
Part 1
1. What is the serial number of your
network Controller? (See page 13 for
information on locating your Controller
serial #.)