User's Manual

3
Safety Instructions
When using your telephone equipment, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and injury.
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not use this product near water or when you are wet (for example, near a
bath tub, kitchen sink, laundry tub, wash bowl, wet basement, or swimming
pool). Unplug this product from the wall outlet before cleaning. Do not use liquid
cleaners or aerosol cleaners. Use a damp cloth for cleaning. Do not plug the
product back in until it is thoroughly dry.
4. Avoid using a telephone (other than a cordless one) during an electrical storm.
There may be a remote risk of electric shock.
5. Do not use a telephone in the vicinity of a gas leak. If you suspect a gas leak,
report it immediately using a telephone located away from the area where the
gas is leaking. Also make sure the Controller unit is located away from the area
of the suspected leak.
6. This product should be operated only from the type of power source indicated
on the marking label. If you are not sure of the type of power supply to your
home, consult your dealer or local power company.
7. Do not overload the wall outlets or extension cords as this can result in the risk
of fire or electric shock.
8. Do not allow anything to rest on the power cord. Do not locate this product
where the cord will be abused by people walking on it.
9. This product must not be installed in an attic or in any other temperature-
extreme environment.
10. To reduce the risk of electric shock, do not disassemble the telephone
equipment. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect reassembly could cause electric shock. If
service or repair work is required, take the unit to a qualified technician.
11. Unplug this product from the wall outlet and refer servicing to qualified service
personnel under the following conditions:
• The power cord is damaged or frayed.
• Liquid has been spilled into the product.
• The product has been exposed to rain or water.
• The product has been dropped or the cabinet has been damaged.
• The product exhibits a distinct change in performance
• The product does not operate normally by following the operating
instructions. Adjust only those controls that are covered by the operating
Safety Instructions