Installation Guide

Parts List
ITEM
QTY
PART NUMBER
DESCRIPTION
1 4 HFN 1213 HEX FLANGE NUT
2 2
CM-SP16 .250 x 1.50 x 2.00" ROUND HOLE SPACER
3 2 1/2-13 x 1 1/4 HEX BOLT
4 2 1/2-13 x 1 HEX BOLT
5
2 1/2" CONICAL TOOTH WASHER
6 1 1/2" FISHWIRE
7
2 1/2-13
HANDLE NUT
8 2
CM-SP3 .250 x 1.25 x 2.00" SQUARE HOLE SPACER
9 2 1/2-13 x 1 1/4 CARRAIGE BOLT
UNDERCARRAIGE DEFLECTOR
NOTCH PATTERN
GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME: MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
3,500 350
20
45
31060 JEEP WRANGLER UNLIMITED
12/17/2012
7
8
9
1
4
5
6
FRONT FRAMERAIL ASSM.
BOTTOM OF BUMPER
B
A
B
C
C
1) Remove undercarraige deflector from vehicle by removing six plastic screw fasteners.
(Tip: To remove fasteners squeeze pointed tip and unscrew using phillips screw driver.)
2) Raise hitch into position and align holes in frame with holes in hitch.
3) Fasten hitch to bottom of bumper using supplied hardware and hand tighten.
4) Fishwire 1/2" carraige bolts and spacers through bottom hole of frame rails and secure. Some
models may require hole enlargement on the driver side frame rail.
5) Install remaining hardware as shown.
6) Torque all 1/2" hardware to 110 lb-ft.
7) (Optional - if reinstalling undercarraige deflector on vehicle, notch as shown to allow clearance
for corresponding hitch components.)
- NO DRILLING REQUIRED
- DEFLECTOR TRIMMING OPTIONAL
- HOLE ENLARGEMENT MAY BE
REQUIRED
C
C
B
B
1
2
3
WILL NOT WORK WITH OPTIONAL BUMPERS
SOME MODELS MAY REQUIRE HOLE ENLARGEMENT