Replacement Part List

STEP 3d
Raise plow and reposition the two front wheel brackets 180 degrees ( g. 25) and the one
rear wheel bracket 90 degrees ( g. 26) for plowing mode.
STEP 3e (Check oil level on hydraulic models)
Raise and lower (and angle left & right if equipped with power angling) plow 10 times to
automatically purge the air out of the hydraulic system. Lower plow to ground and turn
o controller. Check  uid level in hydraulic unit ( g. 27) and top o if necessary ( g. 28)
(see step 1d). Attach Hydraulic Cover to Hydraulic Assembly Lift Frame using two Cover
fasteners on each side ( g. 29). (The cover fasteners are locked in place when the center
nail of the cover fastener is pushed in)
Auto Angling Controller Operation
(Part #22826): Turn the controller on. When turned on the controller will illuminate. The Plow
UP and Plow DOWN switch is a 3 position switch. The plow can be raised “up” by pressing on the top half
of the Plow Up/Plow Down switch. Once released, the switch will return to the center position. The plow
can be lowered by pressing the bottom half of the Plow Up/Plow Down switch. This will stay in the Down
or “Float” position until the operator pushes the switch to the center position or raise “Plow UP” position.
When the switch is in the Down or “Float” position it will keep the S1 valve energized which will allow the
plow to remain in contact with the ground regardless of grade. When the switch is in the center position it
will not allow the plow to lower automatically when encountering a di erent grade. Make sure controller
is turned o when plow is not in use.
Power Angling Controller Operation
(Part #22827): Turn the controller on by holding down the on/o switch until the controller
lights up (1 second). To raise the plow press the up arrow. To angle the plow left press the left arrow and to
angle the plow right press the right arrow. The plow can be lowered by pressing the lower (down) arrow. If
the lower button is pressed for more than 1 second the plow will go into “Float”. “Float” position will keep
the S1 valve energized which will allow the plow to remain in contact with the ground regardless of grade.
Pressing the raise arrow will take the plow out of Float and will not allow the plow to lower automatically
when encountering a di erent grade. The controller has timers built in for safety. The plow will only raise
continually for 4 seconds at a time and angle left or right continually for 6 seconds at a time. The controller
will automatically shut down the function being used if the timer values (4 seconds for raise and 6 seconds
for angle) are exceeded. In order to reset simply release the function being pressed and this will reset the
timer and controller. Make sure controller is turned o when plow is not in use.
Wireless Controller Operation
(Part #22891): Press the up arrow to raise the plow and the down arrow to lower the plow.
A blue light will illuminate when either button is pressed. If it does not illuminate, the remote battery will
need replaced. When using the linear actuator, the raise and lower function will time out after 6 seconds of
continuous up or down. When using the hydraulic unit, the raise function will time out after 3 seconds of
continuous operation.
(Fig. 25)
(Fig. 26)
(Fig. 27)
(Fig. 28)
(Fig. 29)
1
24
7, 12, 16, 19, 20, 21
SAFETY PRECAUTIONS - See pages 2-3 for de nitions
8