Instructions / Assembly

STEP 1a
Connect Plow Assembly to Hydraulic Assembly (g. 1) using
5/8-11 x 5” Bolt (g. 2) and 5/8-11 Locknut (g. 3) from the
Mounting Hardware Bag.
STEP 1b
Attach the two wheel assemblies with the shorter brackets to
either side of the plow pivot bar (g. 4 & 5) and the third wheel
assembly to the Hydraulic Assembly A-frame under the lifting
cylinder using three Hair Pin Cotter (g. 6) from the Mounting
Hardware Bag.
STEP 1c
Attach the Auto or Power Angling Ram to the A-Frame using two
1/2 x 3” Pivot Pins (g. 7), six 1/2” Flatwashers and two
1/8” x 1-5/16” Hair Pins (g. 8). Be sure four 1/2” washers are
positioned as shown in gure 8 and remaining two 1/2” washers
are placed over the 1/2” x 3” Pivot Pins before the two 1/8” 1-5/16”
Hair Pins are installed. Figure 9 shows the proper set-up with the
Power Angling Ram.
STEP 1d
Remove Reservoir Cap from Hydraulic unit (g. 10) and ll with
Meyer M-1 Fluid (g. 11) Provided up to the full mark located on
the reservoir. Re-install Reservoir Cap.
STEP 1:
PLOW & HYDRAULIC LIFT FRAME ASSEMBLY
(Fig. 1) (Fig. 2) (Fig. 3)
(Fig. 4) (Fig. 5) (Fig. 6)
(Fig. 7) (Fig. 8)
(Fig. 9)
(Fig. 10)
(Fig. 11)
6
9, 12
SAFETY PRECAUTIONS - See pages 2-3 for denitions