Use and Care Manual
STEP 3d
Raise plow and reposition the two front wheel brackets 180 degrees (g. 25) and the one rear wheel bracket
90 degrees (g. 26) for plowing mode.
STEP 3e
Raise and lower (and angle left & right if equipped with power angling) plow 10 times to automatically
purge the air out of the hydraulic system. Lower plow to ground and turn o controller. Check uid level in
hydraulic unit (g. 27) and top o if necessary (g. 28)(see step 1d). Attach Hydraulic Cover to Hydraulic
Assembly Lift Frame using two Cover fasteners on each side (g. 29). (The cover fasteners are locked in place
when the center nail of the cover fastener is pushed in)
Auto Angling Controller Operation
(Part #22826): Turn the controller on. When turned on the controller
will illuminate. The Plow UP and Plow DOWN switch is a 3 position switch. The
plow can be raised “up” by pressing on the top half of the Plow Up/Plow Down
switch. Once released, the switch will return to the center position. The plow can
be lowered by pressing the bottom half of the Plow Up/Plow Down switch. This
will stay in the Down or “Float” position until the operator pushes the switch to
the center position or raise “Plow UP” position. When the switch is in the Down
or “Float” position it will keep the S1 valve energized which will allow the plow
to remain in contact with the ground regardless of grade. When the switch is
in the center position it will not allow the plow to lower automatically when
encountering a dierent grade. Make sure controller is turned o when plow is
not in use.
Power Angling Controller Operation
(Part #22827):
Turn the controller on by holding down the on/o
switch until the controller lights up (1 second). To raise the plow press the up
arrow. To angle the plow left press the left arrow and to angle the plow right
press the right arrow. The plow can be lowered by pressing the lower (down)
arrow. If the lower button is pressed for more than 1 second the plow will go
into “Float”. “Float” position will keep the S1 valve energized which will allow the
plow to remain in contact with the ground regardless of grade. Pressing the raise
arrow will take the plow out of Float and will not allow the plow to lower
automatically when encountering a dierent grade. The controller has timers
built in for safety. The plow will only raise continually for 4 seconds at a time
and angle left or right continually for 6 seconds at a time. The controller will
automatically shut down the function being used if the timer values (4 seconds
for raise and 6 seconds for angle) are exceeded. In order to reset simply release
the function being pressed and this will reset the timer and controller.
Make sure controller is turned o when plow is not in use.
11
(Fig. 25)
(Fig. 26)
(Fig. 27)
(Fig. 28)
(Fig. 29)
1
24
7, 12, 16, 19, 20, 21
SAFETY PRECAUTIONS -
See pages 2-3 for denitions