Parts List

Homewerks.com

INSTALLATION INSTRUCTIONS (Continued)

5. Position the fan housing (A) so the bottom edge of the fan

housing (A) is ush with the ceiling board. Do not the ush

mount the fan housing (A) to the joist.

Attach the end of each of the suspension brackets (C, D, E)

to the ceiling joists using wood screws (AA).

6. Secure the suspension brackets (C, D, E) to the fan housing (A)

using machine screws (BB).

7. Slide the duct connector (F) into the tabs on the fan housing (A)

until the duct connector (F) snaps rmly into place over the

opening in the fan housing (A).

NOTE: Remove the protective tape on the duct adapter (F) ap.

8. Install the wall switch according to the wiring diagram on page 5.

Remove the wiring box cover from the fan housing (A). Pull the

house wires through the hole in the wiring box cover. Using the

quick connectors, connect the house wiring to the wall switch (G)

and fan housing (A). 14 AWG is the smallest conductor that

should be used for branch circuit wiring. Please refer to the

wiring diagram on page 5 to ensure proper wire connections are

made. Carefully push the wire connections into the wiring box and

reattach the wiring box cover.

NOTE: Do not use metal wall plate with the wall switch (G), as it

may cause interference with the fan operation.

CAUTION: The switch included with this ventilation fan requires

a neutral wire connection. If a neutral line is not present, one

must be run by a qualied electrician. If you require assistance,

please call 1-877-319-3757 before attempting switch installation.

CAUTION: This switch is intended to only operate with this

bath fan. Connections to other electrical xtures are prohibited

and could cause electrical issues.

Quick

connector