Instructions / Assembly

9
www.homewerksww.com
ASSEMBLY INSTRUCTIONS
Wall switch
back view
White
wire
Black
wire
Red
wire
Green
wire
Wall
switch
NIGHT
LIGHT
8
9
7. Secure the suspension bracket I (C) to fan housing using
screw (CC) (included). Secure suspension brackets (D & E)
with screws (BB) (included).
8. Remove junction box cover. As shown in wiring diagram on page
5, using quick connect ports connect house wires to switch and
fan.
Note: Do not use metal wall plate with the switch, as it may
cause interference with the fan operation.
ATTENTION: The switch included with this ventilation fan
requires a neutral wire connection. If a neutral line is not present,
one will have to be ran by a qualied professional.
Please see the Wiring Diagram on page 5 of your instruction
manual. If you require assistance, please call 1-877-319-3757
before attempting this switch installation.
NOTE: This switch is intended to only operate independently
with this bath fan, connections to other electrical xtures should
be avoided.
9. Connect a 4 in. circular duct and vent to the outside. Secure it
with duct tape or clamp (not supplied).
Turn on power source. Test the fan.
7
1. Join the connectors for the BLUETOOTH
®
speaker (black
wires), light (white wires), and RF receiver (gray wires).
BLUETOOTH
®
SPEAKER FAN GRILLE INSTALLATION
Housing must be installed ush with ceiling board or the grille mounting spring will not be long
enough to insert into the slots inside the fan housing.
1