SDS

产品规格书 （ Product Specification ） 型号（ Model No. ） GLP503450 1000mAh 3.7V
4.2 Mechanical characteristics
机械特性
NO. Items Test Method and Condition Criteria
1 Vibration Test
振动测试
After standard charging, fixed the cell to
vibration table and subjected to vibration
cycling that the frequency is to be varied
at the rate of 1Hz per minute between
10Hz an 55Hz,the excursion of the vibra-
tion is 1.6mm.The cell shall be vibrated
for 30 minutes per axis of XYZ axes.
将标准充电后的电池固定在振动台上，
沿 X、Y、Z 三个方向各振动 30 分钟，
振幅 1.6 mm，振动频率为 10Hz~55Hz，
每分钟变化为 1Hz。
No leakage
无泄漏
No fire
不起火
2 Drop Test
跌落测试
The cell is to be dropped from a height of
meter twice onto concrete ground.
将标准充电后的电池从 1 米高度跌落至
混凝土地面 2 次
No fire, no leakage.
无起火、无泄漏
4.3 Visual inspection
There shall be no such defect as scratch, flaw, crack, and leakage, which may adversely affect commercial value of the cell.
外观检查
不允许有任何影响电池性能的外观缺陷，诸如裂纹、裂缝、泄漏等。
4.4 Standard environmental test condition
Unless otherwise specified, all tests stated in this Product Specification are conducted at below condition:
Temperature：23±5℃
Humidity: 65±20%RH
标准测试环境
除非特别说明，本标准书中所有测试均在以下环境条件下进行：
温度：23±5℃
湿度：65±20%RH
5.Storage and Others
贮存及其它事项
a) Long Time Storage
If the Cell is stored for a long time, the cell’s storage should be 3.6~3.9V and the cell is to be stored in a condition as
No.4.4。
长期贮存
长期贮存的电池（超过 3 个月）须置于干燥、凉爽处。贮存电压为 3.6~3.9V 且贮存环境要求如 4.4。
b) Others
Any matters that this specification does not cover should be conferred between the customer
其它事项
任何本说明书中未提及的事项，须经双方协商确定