SDS

产品规格书 （ Product Specification ） 型号（ Model No. ） GLP503450 1000mAh 3.7V
4.Battery PACK Performance Criteria
电池性能检查及测试
4.1 Electrical characteristics 充放电性能
NO. Items Test Method and Condition Criteria
1
Standard Charge
标准充电
Charging the cell initially with constant current at 0.5C to
4.2V and then with constant voltage at 4.2V till charge cur-
rent declines to 0.05C
先用 0.5C 恒流充电至 4.2V，再恒压 4.2V 充电直至充电电
流≤0.05C
2
Rated Capacity
初始容量
The capacity means the discharge capacity of the cell, which
is measured with discharge current of 0.2C with 3.0V cut-off
voltage after standard charge.
该容量是指标准充电后，0.2C 放电至 3.0V 截止电压所放
出的容量。
≥1000mAh
3
Cycle Life
循环寿命
IEC62133:2002
≥500
cycles
4
Self-discharge
自放电
After the standard charging, storied the cells under the condi-
tion as No.4.4 for 30 days, then measured the capacity with
0.2C till 3.0V
标准充电后，在 No.4.4 条件下贮存 30 天，再以 0.2C 放电
至 3.0V 所放出的容量。
Residual capacity >90%
剩余容量>90%
5
Initial impedance
初始内阻
Internal resistance measured at AC 1KHz after 50% charge 半
充状态下，测量其 AC 1KHz 下的交流阻抗
≤120m
6
PACK Voltage
电池电压
As of shipment.
出货状态
3.6V~3.9V
7
Temperature
Characteristics
温度特性
1. According to item 4.1.1, at 23±5℃.
2. Capacity comparison at each temperature, measured
with constant discharge current 0.2C with 3.0V
cut-off.
Percentage as an index of the capacity compared
with 100% at 23℃
1.在 23±5℃条件下，用 4.1.1 方法将电芯充电。
2.在不同温度条件下，用 0.2C 的电流恒流放电至截止电
压 3.0V。以 23℃时放电容量为基准计算百分比。
-20℃: ≥65%
23℃: 100%
60℃: ≥90%
8
Storage
Characteristics
储存特性
1. According to item 4.1.1,at 23±5℃.
2. The battery shall be stored at 80±5℃ for 4 hours
(measure thickness ) and rested at room temperature
for 1 hour then measured with constant discharge
current 0.2C with 3.0V cut-off.(measure Capacity)
1. 在 23±5℃条件下，用 4.1.1 方法将电芯充电。
2.将电池在 80±5℃条件下贮存 4 小时，然后在常温下静
置 2 小时，用 0.2C 的电流恒流放电至 3.0V 截止电压。
Retained Capacity
≥95%
Retained Thickness
≤10%