SDS

产品规格书 （ Product Specification ） 型号（ Model No. ） GLP503450 1000mAh 3.7V
3.6V and 3.9V.
Over-discharging may causes loss of cell performance, characteristics, or battery functions.
The charger shall be equipped with a device to prevent further discharging exceeding a cut-off voyage specified in the
Product Specification. Also the charger shall be equipped with a device to control the recharging procedures as fol-
lows:
The cell battery pack shall start with a low current (0.01C) for 15-30 minutes, i.e.-charging, before rapid charging
starts. The rapid charging shall be started after the (individual) cell voltage has been reached above 3V within 15-30
minutes that can be determined with the use of an appropriate timer for pre-charging. In case the (individual) cell
voltage does not rise to 3V within the pre-charging time, then the charger shall have functions to stop further charging
and display the cell/pack is at abnormal state.
过放电需要注意的是，在电池长期未使用期间，它可能会用其它自放电特性而处于某种过放电状态。为防止放
电的发生，电池应定期充电，将其电压维持在 3.6V 至 3.9V 之间。
过放电会导致电池性能、电池功能的丧失。
充电器应有装置来防止电池放电至低于本标准书规定的截止电压。此外，充电器还应有装置以防止重复充电，
步骤如下：
电池在快速充电之前，应先以一小电流（0.01C）预充电 15~30 分钟，以使（每个）电芯的电压达到 3V
以上，再进行快速充电。可用一记时器来实现该预充电步骤。如果在预充电规定时间内，（个别）电池的
电压仍未升到 3.0V 以上，充电器应能够停止下一步快速充电，并显示该/电池正处于非正常状态。
3. Storage
贮存
The cell shall be storied within -10℃~60℃ range environmental condition.
If the cell has to be storied for a long time (Over 3 months),the environmental condition should be:
Temperature: 23±5℃
Humidity: 65±20%RH
The voltage for a long time storage shall be 3.6V~3.9V range.
电池储存温度必须在-10℃~60℃的范围内。
长期存储电池（超过 3 个月）须置于温度为 23±5℃、湿度为 65±20%RH 的环境中。
贮存电压为 3.6V~3.9V
4. Handling of Cells
电池操作注意事项
Since the battery is packed in soft package, to ensure its better performance, it’s very important to carefully handle the
battery
由于电池属于软包装，为保证电池的性能不受损害，必须小心对电池进行操作。
4.1 Soft Aluminum foil
The soft aluminum packing foil is very easily damaged by sharp edge parts such as Ni-tabs, pins and needles.
·Don’t strike battery with any sharp edge parts
·Trim your nail or wear glove before taking battery
·Clean worktable to make sure no any sharp particle
铝箔包装材料易被尖锐部件损伤，诸如镍片，尖针。