SDS

产品规格书 （ Product Specification ） 型号（ Model No. ） GLP503450 1000mAh 3.7V
电性能、机械性能和安全性能的问题，并可能会导致发热或泄漏。
1.2 Charging voltage:
Charging shall be done by voltage less than that specified in the Product Specification (4.2V/cell). Charging beyond
4.25V, which is the absolute maximum voltage, must be strictly prohibited. The charger shall be designed to comply
with this condition.
It is very dangerous that charging with higher voltage than maximum voltage may cause damage to the cell electrical,
mechanical safety performance and could lead to heat generation or leakage.
充电电压
充电电压不得超过本标准书中规定的额定电压（4.2V/电芯）。4.25V 为充电电压最高极限，充电器的设计应满
足此条件。
电芯电压高于额定电压值时，将可能引起电池的充放电性能、机械性能和安全性能的问题，可能会导致发热
或泄漏。
1.3 Charging temperature:
The cell shall be charged within 0℃~60℃ range in the Product Specification.
充电温度
电池必须在 0℃~60℃的环境温度范围内进行充电。
1.4 Prohibition of reverse charging:
Reverse charging is prohibited. The cell shall be connected correctly. The polarity has to be confirmed before wiring,
In case of the cell is connected improperly, the cell cannot be charged. Simultaneously, the reverse charging may
cause damaging to the cell which may lead to degradation of cell performance and damage the cell safety, and could
cause heat generation or leakage.
禁止反向充电
正确连接电池的正负极，严禁反向充电。若电池正负极接反，将无法对电池进行充电。同时，反向充电会
降低电池的充放电性能、安全性，并会导致发热、泄漏。
2. Discharging
放电
2.1 Discharging current
The cell shall be discharged at less than the maximum discharge current specified in the Product Specification. High
discharging current may reduce the discharging capacity significantly or cause over-heat.
放电电流
放电电流不得超过本标准书规定的最大放电电流，大电流放电会导致电池容量剧减并导致过热。
2.2 Discharging temperature
The cell shall be discharged within -20℃~60℃ range specified in the Product Specification.
电池必须在-20℃~60℃的环境温度范围内进行放电。
2.3 Over-discharging:
It should be noted that the cell would be at over-discharged state by its self-discharge characteristics in case the cell is
not used for long time. In order to prevent over-discharging, the cell shall be charged periodically to maintain between