SDS

产品规格书 （ Product Specification ） 型号（ Model No. ） GLP503450 1000mAh 3.7V
5 Cell P503450-1C 1000mAh 1
Appendix
附录 Handling Precautions and Guideline
For LIP(Lithium-Ion Polymer)Rechargeable Batteries
聚合物锂离子充电电池操作指示及注意事项
Preface
This document of’ Handling Precautions and Guideline LIP Rechargeable Batteries shall be applied to the battery
cells manufactured.
前言
本文件“聚合物锂离子充电电池操作指示及注意事项”仅适用于聚合物电池。
Note(1):
The customer is requested to contact factory in advance, if and when the customer needs other applications or oper-
ating conditions than those described in this document. Additional experimentation may be required to verify per-
formance and safety under such conditions.
声明一：
客户若需要将电池用于超出文件规定以外的设备，或在文件规定以外的使用条件下使用电池，应事先联系工
厂，因为需要进行特定的实验测试以核实电池在该使用条件下的性能及安全性。
Note(2):
Factory will take no responsibility for any accident when the cell is used under other conditions than those de-
scribed in this Document.
声明二：
对于在超出文件规定以外的条件下使用电池而造成的任何意外事故，工厂概不负责。
Note(3):
Factory will inform, in a written form, the customer of improvement(s) regarding proper use and handing of the
cell, if it is deemed necessary.
声明三：
如有必要，工厂会以书面形式告之客户有关正确操作使用电池的改进措施。
1. Charging
充电
1.1 Charging

current:
Charging

current should be less than maximum charge current specified in the Product Specification. Charging with
higher current than recommended value may cause damage to cell electrical, mechanical and safety performance and
could lead to heat generation or leakage.
充电电流
充电电流不得超过本标准书中规定的最大充电电流。使用高于推荐值电流充电将可能引起电池的充放