Use and Care Manual
Customer Service Hotline 1-877-693-PURE
Page 7
Home Master® Reverse Osmosis System—Owners Manual
B) RO Faucet: Insert BLUE 3/8” tubing into RO faucet adapter. Push tubing all the
way in, then pull back gently to check fit. Push twice to be sure its really in.
C) Reserve tank- Insert BLACK 3/8” tubing into the tank shut off valve. Push tubing
all the way in, then pull back gently to check fit.
D) Drain — Locate the black plastic nut found in drain saddle parts bag. Press it onto
the RED 1/4” tubing attached to the filter cluster. The red tubing should protrude
from the black plastic nut slightly. Wrap excess tubing around the drainpipe so that
some loops are above the drain saddle. Hand tighten black plastic nut onto the
drain saddle male fitting until it is snug. Do not over tighten and please DO NOT
add a tubing insert.
8. Pressurize the Home Master® RO - For UV filter equipped systems first
connect power adapter to UV filter so the UV filter cap glows. If unit fails to
illuminate, then check power outlet with a known good device like a lamp. Many
undersink outlets are switched.
Make sure unit is dry. Double check to make sure all valves are in the closed
position, except for the main angle-stop valve, which should be open. Water
should flow normally from your kitchen faucet. SLOWLY open the EZ adapter ball
valve. You should hear water rushing through the system. Open the RO faucet to
by flipping the lever up, where it should stay open. A trickle of water should be
present after 2-20 minutes. Some blackening of the water may present due to
loose carbon being flushed out. Close the lever on the RO faucet after the trickle
runs clear, and allow the system to pressurize. When the system has
pressurized and shuts off automatically <IMPORTANT STEP> dry unit
thoroughly, gently tug on each connection and check for leaks. Then
open the reserve tank valve slowly. Allow 1-3 hours for reserve tank to fill.
System will produce waste water while producing clean water. The system will
produce waste water in tandem with product water.
9. Fill and Drain Procedure—First close the EZ adapter ball valve so that the
system is no longer producing new water, then open the RO faucet. Let the
water run out until it comes to a COMPLETE STOP. Close RO faucet. Slowly
open the EZ adapter ball valve and let the system refill, then repeat this step.
System must be flushed at least twice prior to use. Some harmless fine
air bubbles may be present and will dissipate with time and use. [OPTIONAL-
Following successful fill and drain procedure you may plug in refrigerator
electric plug; open refrigerator connection kit ball valve. Make sure refrigerator
icemaker and water center are turned ON. Check for leaks. Check for pressure
at the refrigerator’s water center. Flush the water center until the water
runs clear and is at room temperature; and dispose of the first two
batches of ice following new installation, and after filter changes. Use
caution when rolling refrigerator back into place. DO NOT crimp or crush water
line, as a leak will likely develop.]