Use and Care Manual

Customer Service Hotline [phone]-PURE
Page 5
Home Master
®
Water Filter Owners Manual
12. Check pipe length and pipe union length to see if additional pipe length or union
required. Join pipe union and pipe.
13. Fit pipe hanger on water OUT side for additional support. Connect ground jumper
cable (if necessary)
14. A) Remove each filter from its packaging, B) replace it in the sump taking care
that it slots over the standpipe at the bottom of the sump,
15. IMPORTANT:
YOU MUST APPLY
GREASE TO THE
ENTIRE SURFACE
OF BOTH ORINGS
AND HOUSING
THREADS - TO
ENSURE SMOOTH
OPERATION,
OPENING ,
CLOSING, AND A
PROPER SEAL.
FAILURE TO DO SO
WILL LEAD TO
INCOMPLETE
CLOSURE & LEAKS,
OR MAKE IT
NEARLY
IMPOSSIBLE TO
OPEN THE UNIT
SOME GREASE IS ADDED AT THE FACTORY. PLEASE ADD MORE.
16. NOTE FILTER ORDER: The SEDIMENT filter treats the water first. The CARBON filter
treats the water last. In 3 housing units the IRON or Nanofiber filter will be in the
center position.
17. Fit sump with filter to housing cap hand-tighten, then fit snug with housing
wrench. Housing is closed when a 1/8” gap is observed between cap and lower lip.
Turing the water back on
Turn your water on slowly. In a few minutes, the sound of water entering the system
will stop. After the unit is installed, it is necessary to flush the unit thoroughly. Do this