Use and Care Manual

Customer Service Hotline [phone]-PURE
Page 3
Home Master
®
Water Filter Owners Manual
Installing The Whole House Filtration System
Tools Required
Safety glasses hacksaw
Towels Soldering iron or torch
Flat head screwdriver Power drill
Medium Crescent wrench Teflon tape
Monkey wrench
Parts required (not included)
(2) shut off valves bypass valve (s) (optional)
(2) hex nipples or pipe nipples pressure gauge (s) (optional)
(2) pipe unions pressure regulator (as needed)
(1) ground jumper cable
(2) pipe hangers
Preliminary Notes
 This installation guide provides a step by step, start to finish procedure
for installing your Home Master® water filter.
 All steps provided herein are for typical installations only. You application
may be different.
Pre-Installation
 For well water - SHOCK CHLORINATE your well and pipes immediately
prior to installation and every filter change.
 Filter should be protected from freezing, direct sunlight, extreme
temperatures, kept dry and level.
 Make a list of all the plumbing fittings and tools you will need to
completely install the system according to your application.
 Turn the water off to your house while installing the system.
 Turn off the electricity to your electric water heater during installation.
After the system is installed and pressurized, turn on a few hot and cold-
water faucets, and let them run until there is no more air in your lines,
then turn the electricity back on to your water heater.
 Use Teflon tape on threaded fittings.
 Be sure to note inlet and outlet markings. The sediment filter is the first
stage of the water filter.
 A three-valve by-pass valve and loop may be installed to loop the entire