Operation Manual

ENGLISH

CLEANING AND CARE, TECHNICAL DATA

• Disconnect the power plug (1) and allow the device to cool down completely, before cleaning it.

• Remove the blender wand (6) from the motor unit (5). To do so, turn the blender wand until the marking on

the blender wand and the open lock symbol on the motor unit are aligned.

• Clean the blender wand and the cutting blades immediately after use with warm water and some washing

up liquid. Dry the blender wand well, before using it again.

• Caution! Risk of injury! The cutting blades of the blender wand are very sharp! Proceed with caution

when you are handling them.

• Never immerse the motor unit in water or other liquids, when you are cleaning them. Never hold these parts

under running water.

• Clean the outside surfaces of the motor unit with a slightly moist cloth and rub them dry.

• Some foods, e.g. carrots, may stain the plastic. Use a cloth dipped in vegetable oil to partially remove the

colour residue on the affected area.

• Never use solvents and scouring powder, hard brushes and metallic or sharp objects to clean the device.

Solvents are dangerous to our health and have an adverse effect on plastic parts. Abrasive cleaners and

materials scratch the surface.

Technical data

Power supply 220-240V~, 50Hz

Power consumption 500 W

Operating time Short time operation: 10 seconds operation / 1 minute pause

Manufactured for JGC-Company GmbH

Heckhofweg 146

50739 Köln

Customer Service E2 Servicecenter GmbH

Max-Planck-Strasse 13

50858 Köln-Marsdorf

Telephone

01805- 22 17 84

Monday-Friday,10:00 - 18:00

(Euro 0.14/min from German landline; other charges may apply from

mobile phone)

Please enter the serial number of your

device here:

SM5002W-IM-DE-EN-V1.indb 17 05/02/2010 10:43 AM