Network Router User Manual

Dynamix DW 3512 Technical Manual V1.00

For more information regarding Operation Modes, please refer to CH 4 Wireless Operation

Modes.

Wireless

 Basic Settings

This page is used to configure the parameters for wireless LAN clients which may connect to your

Access Point.

¾ Disable Wireless LAN Interface: If user checks his function, wireless LAN will be disabled. In

other words, this device will not be visible by any wireless station.

¾ Band: Select wireless band as 802.11b, 802.11g, or 802.11b+g.

¾ Mode: Select wireless mode as AP, Client, WDS and AP+WDS. AP mode enables DW3512 to

work as wireless an access point and allow other devices to connect wirelessly to a wired

Ethernet network. Client mode enables DW3512 to perform as a wireless client card and

other devices can connect with Ethernet cable to DW3512. WDS and AP+WDS are used for

Repeate

r. If

AP+WDS is enabled, DW3512 could be working as AP and WDS Repeater

together

Network Type: Only when wireless mode set as client, user can select network type as

infrastructure or Ad hoc. Infrastructure represents a wireless network centered about an

access point. Ad hoc represents a wireless network composed only of stations within mutual

communication range of each other. (No Access Point).

¾ SSID: specify to the DW3512 an SSID (Service Set Identifier),

which is a unique identifier

attached to packet

s over WLAN. The SSID is up to 32 ASCII characters that differentiate the

DW3512 from other WiFi AP, and it is also referred to as the ESSID (Extended Service Set