Instructions / Assembly

Preparing the canopy

Preparing the motor

□ Remove the cotter pin (DD) and clevis pin (CC), and

loosen the two collar setscrews (EE) from the motor

collar.

□ Take out the setscrew (GG) located in the hanger ball

(LL), lower the hanger ball (LL) and remove the cross

pin (FF). Remove the hanger ball (LL) from the hanger

ball/downrod assembly (D).

Assembly

□ Remove the canopy bottom cover (C) from the canopy

(B) by turning the canopy bottom cover (C) counter-

clockwise.

□ Remove the mounting bracket (A) from the canopy (B)

by removing the non-slotted canopy mounting screw

(BB) from the bottom of the canopy (B) and loosening

the slotted canopy mounting screw (BB) a half turn

from the screw head. Next, turn the canopy (B)

counterclockwise to remove the mounting bracket (A)

from the canopy (B).

Assembling the fan

□ Carefully feed the motor wires up through the

downrod (MM). Thread the downrod (MM) into the

collar.

□ Align the holes and replace clevis pin (CC) and cotter

pin (DD). Tighten the two collar setscrews (EE).

□ Slip coupling cover (E), canopy bottom cover (C), and

canopy (B) onto the downrod (MM).

□ Carefully reinstall the hanger ball (LL) onto the

downrod (MM). Ensure that the cross pin (FF) is in the

correct position, the setscrew (GG) is tightened and

the wires are not twisted.

WARNING: Failure to properly install the cotter pin (DD)

could result in the fan loosening and possibly falling.

NOTE: If a longer downrod (not included) is needed, take

out the screw located in the hanger ball (LL), lower the

hanger ball (LL) and remove the pin (FF). Remove all three

pieces from the downrod and assemble them onto the new

longer downrod before proceeding to the downrod installa-

tion.