Installation Guide

Remote Control (continued)

Pair your remote with shade

Long press the motor [up] [Down] key for 3 seconds to enter the

learning/pairing state. Motor will jitter and the LED will be long lit.

①

Hold the [channel left selection]+[Stop] button simultaneously. After

the signal has been received, the motor will shake once and the

motor LED will blink 3 times.

②

Reversing Roll Direction

(only needed for over-the-roll direction shade install)

① ②

Long press the motor [Up] [Down] key for 3 seconds, motor will jitter

and LED indicator will long light.

Press the channel setting button on back of the remote control, shade

will jig and motor LED will ﬂash 4 times, indicating the pairing is

completed. The motor LED will go out.

Modifying shade settings/limits for existing paired shades

Please note that this function can also be performed in Hubspace smart app once enabled.

To avoid other shades from being interfered with while setting upper and lower limits, turn the on/off

switch to the “off” position for all shades that are not in limit setting mode

Only applicable for remote control that is already successfully paired with existing shades. Useful for

adjusting the top and bottom shade limits. On the remote control that has paired successfully, long

press the [channel setting] button of the remote control for 4 seconds. The motor of the shade will jig,

and the shade LED will begin ﬂashing and shade will be sent into pairing mode.