Instructions / Assembly

Finishing the fan installation

Assembly — Hanging the Fan (continued)

NOTE: Adjust the canopy mounting screws as necessary

until the canopy and canopy bottom cover are snug.

WARNING: Make sure the tab on the mounting bracket

properly sits in the groove in the hanger ball before attaching

the canopy to the bracket by turning the housing until it drops

into place.

Make sure connections are neatly tucked into the ceiling

outlet box.

Slide the canopy (B) up to the mounting bracket (A) and

place the key holes on the canopy over the loose canopy

mounting screws (EE) on the mounting bracket (A). Turn the

canopy clockwise until it locks in place at the narrow

section of the key holes. Make sure the positioning pin (NN)

on the mounting bracket falls into one of two holes (OO) on

the canopy, and then tighten the two canopy mounting

screws (EE).

Attach the canopy bottom cover (C) to the canopy (B) by

inserting the screw heads into the key slots in the canopy

bottom cover (C) and rotating it clockwise.

Carefully lift the decorative cover (I) up inside the motor (F)

and secure it to the fan by turning the decorative cover (I)

clockwise until snug.

Please contact 1-877-592-5233 for further assistance.

HOMEDEPOT.COM/HUBSPACE

Outlet Box