Installation Guide

PAGE 15
FIXED PANEL AND SUPPORT BAR INSTALLATION
5.1. Drill a pilot hole for the sliding door guide (A) using a ø1/8 in drill bit.
5.2. Install the sliding door guide (A) with the screw (CC) and the cap (HH).
5.3. Place the 2 support bar anchors (D & P) back on their wall mark, then mark their center on the wall.
5.4-5.5. Drill a hole on the center marks with a ø5/16 in drill bit . If there are no studs located behind the support bar anchors (D
& P), then insert the wall anchors (AA) using a rubber mallet until the wall anchors are ush with the wall. Fix the center tting of
the support bar anchors (D & P) on the wall using the screws (GG).
5
D
A
HELPFUL HINT!
Add a drop of silicone in the
holes before inserting the
screws.
HH
CC
5.1
5.2
5.3
5.4 5.5
ø5/16 in
ø1/8 in
WARNING!
If there are no studs aligned to support bar
anchors behind the drywall, use the wall
anchors to ensure the screws won’t become
loose.
P
GG
D
P
GG
D D
P P
A A
LEFT DOOR OPENINGRIGHT DOOR OPENING
B B