Installation Guide

PAGE 11
FIXED PANEL AND SUPPORT BAR INSTALLATION
2.1. Insert the xed panel bottom seal strip (N) on the base of the xed panel (C). Cut the surplus part with a cutter, about 1 9/16
in from the panel’s edge.
2.2. Insert the xed panel (C) into the wall track (B). Do not fully tighten it as further adjustments may be required.
Note: The wall track (B) allows you to adjust the position of the xed panel (C). Adjusting the depth and/or giving the
glass panel a slight angle allows for out of plumb adjustment.
2.3. Smoothly slide the sliding door guide (A) at the bottom of the xed panel (C), but without securing it.
2
1 9/16 in
B
C
N
C
C
A
2.1
2.3
2.2
C
N
B
C
N
B
LEFT DOOR OPENINGRIGHT DOOR OPENING
A A