Use and Care Manual

Assembly
1
Attaching the Left Side Panel and Right Side Panel to the Table Top
2
Attaching the Back Panel to the Left Side Panel and Right Side Panel
Place the table top (B) upside down on a soft surface.
Do not tighten the bolts at this step.
Attach the left side panel (C) and right side panel (D) to the table top (B) using M6x15 combination bolts (AA), as shown below.
Attach the back panel (F) to the left side panel (C) and right side panel (D) using M6x15 combination bolts (AA).
Do not tighten the bolts at this step.
Pay attention to the direction of control knob and the legs. They must be placed as the step shows.
10
NOTE:
NOTE:
Loosely tighten all the bolts using hex wrench (FF).
NOTE: Loosely tighten all the bolts using hex wrench (FF).
AA
D
C
B
AA
C
D
F