Instructions / Assembly
Connecting the Hose and Regulator to Cylinder
15
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Operation (continued)
Use a standard 20 lb. propane cylinder only (approximately
Every part of the heater shall be secure against displacement and
shall be constructed to maintain a xed relationship between
essential parts under normal and reasonable conditions of handling
and usage. Parts not permanently secured shall be designed so
they cannot be incorrectly assembled and cannot be improperly
located or misaligned in removing or replacing during cleaning or
other servicing.
The propane gas and cylinder are sold separately.
Use this heater only with a propane vapor withdrawal supply
system. See chapter 5 of the standard for storage and handling of
liquied petroleum gas, ANS/NFPA 58. Your local library or re
department should have this book. Storage of an appliance indoors
is permissible only if the cylinder is disconnected and removed
from the appliance. A cylindar must be stored outdoors in a
well-ventilated area out of the reach of children. A disconnected
cylinder must have dust caps tightly installed and must not be
stored in a building, garage or any other enclosed area. The
maximum inlet gas supply pressure: 250 psi/1750kPa. The
minimum inlet gas supply pressure: 25 psi/175 kPa. Manifold
pressure with regulator provided: 11 inch W.C/2.74 kPa. The
pressure regulator and hose assembly supplied with the appliance
must be used. The installation must conform with local codes or in
the absence of local codes, with national fuel gas code, ANS
Z223.1/NFPA54, natural gas and propane Installation Code, CSA
B149.1, or propane storage and handling code, B149.2.
12.2 in./31cm.in diameter and 17.9 in./45.5cm high).
12.2 in. / 31 cm
Standard 20 lb. cylinder
17.9 in. / 45.5 cm