Instructions / Assembly

Preparing the motor

Assembling the fan

Assembly (continued)

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

□ Remove the cotter pin (HH) and clevis pin (GG), and

loosen the two collar setscrews (LL) from the motor

collar.

□ Take out the setscrew #1 (JJ) and loosen the

setscrew #2 (KK) located in the hanger ball (QQ),

lower the hanger ball and remove the cross pin (II).

Remove the hanger ball (QQ) from the hanger ball /

downrod assembly (F).

□ Carefully feed the motor wires and antenna wire (TT)

up through the downrod (RR). Thread the downrod

(RR) into the collar.

□ Align the holes and replace the clevis pin (GG) and

cotter pin (HH). Tighten the two collar setscrews (LL).

□ Slip coupling cover (G), canopy bottom cover (E), and

canopy (D) onto the downrod (RR).

□ Carefully reinstall the hanger ball (QQ) onto the

downrod (RR) and make sure that the cross pin (II) is

in the correct position, the setscrew #1 (JJ) and

setscrew #2 (KK) is tightened and wires are not

twisted.

WARNING: Failure to properly install the cotter pin (HH)

could result in the fan loosening and possibly falling.

NOTE: If a longer downrod (not included) is needed, take out

the screw located in the hanger ball (QQ), lower the hanger

ball (QQ) and remove the cross pin (II). Remove all three

pieces from the downrod and assemble them onto the new

longer downrod before proceeding to the downrod

installation.