Assembly Instructions

ManualsBrandsHome Decorators Collection ManualsElectronicsRemote Controller

Table Of Contents

Installation (continued)

Making The Electrical Connections

WARNING

Verify the power has been disconnected to both the

room and the wall switch before making the

electrical connections. Failure to do so could

or death.

□

If your outlet box has a ground wire (green or bare

copper), connect it to the ground wire on the ceiling

fan’s pivot ball portion of the downrod (B). If there is no ground

wire in your outlet box, connect the ground wire on the pivot ball

portion of the downrod (B) to the ground wire on the mounting

bracket assembly (A).

Connect the white (neutral) supply wire to the white

wire on the remote receiver (I) marked AC in N.

Connect the black (hot) supply wire to the black wire.

□

BLACK

WHITE

GREEN/

YELLOW

GREEN/

YELLOW

Connect the ceiling fan single snap connection plug to the

corresponding outlet on the remote receiver (I).

□

Connect the other ceiling fan single snap connection plug to the

corresponding outlet on the remote receiver (I).

NOTE: When shipped, the electrical wires from the

ceiling fan offer enough length to accommodate

extended length downrods up to 48 in. (not included).

For shorter downrods, including the one provided

with this fan, this excess length is not needed and

should be cut off before making the electrical

connections in order to allow enough room for

the electrical wires so that only 12 in. of electrical

wires extend from the top of the downrod. Failure

to trim the electrical wires as noted may make it

bracket as described in these instructions.

Summary of content (4 pages)

PAGE 1
Installation (continued) 4 Making The Electrical Connections WARNING Verify the power has been disconnected to both the room and the wall switch before making the electrical connections. Failure to do so could A BLACK or death. WHITE WHITE NOTE: When shipped, the electrical wires from the ceiling fan offer enough length to accommodate extended length downrods up to 48 in. (not included).
PAGE 2
Installation (continued) □ Slide the canopy (C) up into place and rotate clockwise to lock to mounting bracket assembly (A). Reinstall the two screws (M4 x 6 mm) removed previously in step 1 and tighten securely. NOTE:If your electrical box has both red and black hot wires, only one of these will be needed. Choose the supply wire that matches the wall switch you want to use for your ceiling fan.
PAGE 3
Installation (continued) NOTE: The decorative arms (F) in the next two steps are not required for operation. You may skip these two steps if you do not wish to install the decorative arms (F). □ Finish the assembly by screwing the finial screw (T) on each arm (F) into the threaded holes in the top lens cover. NOTE: Install the decorative arms (F) using a Phillips head screwdriver. Attach one side of each arm to the center arm support (E) using the Phillips cap screws (BB) and screw covers (CC) as shown.
PAGE 4
Operation 1 2 Mounting The Remote Control Holder Using The Remote Control (Model No: EHU-669) NOTE: If you have not already done so, restore power to the room and wall switch, then make sure the wall switch controlling the fan is turned on. The rempte control (J) will have no effect on the fan if the switch is turned off. □ Remove the screw cover (U) from the remote control holder (V). □ Install the remote control holder (V) in the desired location using the two mounting screws provided.