Users Manual

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.

Assembly - Standard Ceiling Mount (continued)

Assembling the fan

□ Loosen, but do not remove, the setscrew (EE) on the motor

collar (GG) on top of the fan motor assembly (E) by turning it

counterclockwise.

□ Install the ball/downrod (C) by inserting it into the motor collar (GG)

and turning it clockwise until it is tight.

□ Re-tighten the setscrew (EE) on the motor collar (GG) on top of the

fan motor assembly (E) by turning it clockwise.

CAUTION: To ensure wobble-free operation and to avoid

damage to the fan, the ball/downrod (C) and the setscrew

(EE) must be completely tightened.

NOTE: This fan is equipped with a safety tab (FF).

Should the setscrew (EE) ever become loose while the

fan is running in reverse, the safety tab (FF) will engage

and stop the fan from falling.

Attaching the fan to the electrical

box

□ Loosen the two mounting screws (JJ) in the outlet box.

□ Pass the 120-Volt supply wires through the center hole in the

mounting bracket (A).

□ Slide the mounting bracket (A) on to the mounting screws (JJ)

and center the mounting bracket (A) in relation to the outlet box.

If necessary, use leveling washers (not included) between the

slide-on mounting bracket (A) and the outlet box. The at side of

the slide-on mounting bracket (A) should face toward the outlet

box, as shown.

□ Securely tighten the two mounting screws (JJ).

WARNING: To reduce the risk of re, electric shock

or personal injury, mount to outlet box marked

“Acceptable for fan support of 35 lbs 15.9 kg) or less”,

and use screws provided with the outlet box.

NOTE: The mounting bracket (A) is designed to slide

into place on an outlet box with the mounting screws

(JJ) installed.

Assembly - Hanging the Fan