Instructions / Assembly

Problem: The shade will not retract properly
Troubleshooting
Hold the shade in the middle of the pull bar and gently
pull the shade down to the desired position and
release.
To raise the fully opened position of the shade, firmly
hold the shade roll so it does not turn and wrap the the
hanging portion of the shade over the top and around
the back of the shade roll.
Possible Cause: The end cap pin(s) may not be fully inserted into the
mounting brackets.
Solution: Slightly rotate the Shade (A) within the mounting brackets to fully
seat the pin(s).
NOTE: Make sure the end cap pins are fully INSERTED into the spring
brackets firmly.
NOTE: It may be necessary to completely remove the shade from the
brackets to properly seat the pin(s).
To lower the fully opened position of the shade, firmly hold
the shade roll so it does not turn and unwrap the hanging
portion of the shade from the back and over the top of the
shade roll.
Hold the shade in the middle of the pull bar and gently
push the shade up to the desired position and release.
Lowering the Shade Raising the Shade
Operation
5
Adjust Full Open Position
The amount of fabric hanging from the shade when in its fully open position can be modified without increasing the
spring motor tension by wrapping the fabric around the shade roll or unwrapping the fabric from around the shade roll.
NOTE: Do not remove the shade
from the mounting brackets to
make this adjustment.
Problema: La cortina no se retrae correctamente
Solución de problemas
Sostener la cortina por la mitad de la barra para jalar
y jalar suavemente de la cortina hacia abajo hasta la
posición deseada y soltar.
Para levantar la posición completamente abierta de la
cortina, sostener firmemente el rollo de la cortina para
que no gire y envolver la parte que cuelga de la cortina
sobre la parte superior y hacia atrás del rollo de la
cortina.
Causa posible: El(los) sujetador(es) de la tapa del extremo posiblemente no
estén insertados completamente dentro de los soportes de montaje.
Solución: Rotar levemente la Cortina (A) dentro de los soportes de montaje
para acomodar completamente el(los) sujetador(es).
NOTA: Asegurarse de que los sujetadores de la tapa del extremo estén
completamente INSERTADOS en los soportes de resortes de manera firme.
NOTA: Es posible que sea necesario retirar completamente la cortina de los
soportes para acomodar el(los) sujetador(es) correctamente.
Para bajar la posición completamente abierta de la cortina,
sostener firmemente el rollo de la cortina para que no gire
y desenvolver parte de la cortina desde la parte de atrás y
sobre la parte superior del rollo de la cortina.
Sostener la cortina por la mitad de la barra para jalar
y empujar suavemente la cortina hacia arriba hasta la
posición deseada y soltar.
Bajar la cortina Levantar la cortina
Funcionamiento
5
Ajustar la posición completamente abierta
La cantidad de tela que cuelga de la cortina cuando está en la posición completamente abierta puede modificarse sin
aumentar la tensión del motor del resorte envolviendo la tela alrededor del rollo de la cortina o desenvolviendo la tela
de alrededor del rollo de la cortina.
NOTA: No retirar la cortina de los
soportes de montaje para realizar
este ajuste.
IM - Solar Pushup Roller Shade w headrail - English-Spanish-Final.indd 9-10 11/30/17 6:41 PM