- HAI (Home Automation Inc.) Network Digital Video Recorder Installation and User Guide

2.3. Confirm communications

To confirm communications, click the ‘Ping test’ button. Confirmation of

communications should look similar to the following:

Reply from 192.168.1.2: byte=32 time=2ms TTL=225

Communication failure would look similar to the following:

Request timed ‘OUT’

statistics for 192.168.1.2:

If some, or all, of the packets are lost, repeat the ‘ping’ command again. If you keep

getting the ‘Request timed Out’’ message, check the following:

• The 68A00-1 is connected to power and turned on.

• Cable connections (between 68A00-1 and PC) or (68A00-1, PC, and HUB).

• IP addresses assigned to the 68A00-1 and PC are in the same subnet mask.

After confirming the items above, rerun IP Setup and reassign the IP to the 68A00-1.

3. Setup of the 68A00-1

Access the 68A00-1 admin page to set the 68A00-1 operational configurations.

• In the IP Setup program, click the ‘Launch admin page’ button or

• Open Internet Explorer.

• Enter the IP address in the URL box in the browser as below:

http://(IP address)/admin_login.html

For example:

http://192.168.1.2/ admin_login.html

The default ID is “admin” and password is “pass”.

It is strongly recommended that you change the ID & Password to prevent anonymous

connections. For further information, please refer to Chapter 5.

68A00-1 NETWORK DIGITAL VIDEO RECORDER