Topside Control Instructions for Single Pump Spas 15vs300vl24002 For technical support and assistance, call 844-894-6659 1
POWERING ON YOUR SPA After filling the spa through the filter assembly to the correct level and removing the water hose, replace the filter, the filter basket assembly and filter cover. Turn the GFCI on. Every time the GFCI is powered on, your spa controls run diagnostic self checks. During diagnostic testing, it is normal for a series of messages to display on your topside controls. When diagnostic self checks are completed, the spa will start in priming mode.
Pre-Programmed Factory Settings The spa will start in Standard Operating Mode. The temperature is pre-programmed to 100° F. The minimum programmable temperature is 80º F, the maximum is 104º F The Filtration cycle is pre-programmed to run for twice each day for two hours. 100 While the water is heating, the temperature is measured approximately every two minutes. After the spa has been running for 2 minutes, the current water temperature will be displayed on the topside controls.
Turning the Lights On and Off Press the “Light” button once to turn the lights on. The colored light will rotate. Press the “Light” button to turn the light off. To display only one color, press the “Light” button repeatedly turning the lights on and off. When the color your desire turns on do not turn the light off. Press the button when you are ready to turn the light off. If the “Light” button is not pressed to turn the lights off manually, the lights will turn off automatically after 2 hours.
Changing the Programmed Temperature Setting To change the pre-programmed temperature setting, press the “cool” button once. The programmed water temperature will flash on the display. While the programmed water temperature is still flashing press the “cool” button again to reduce the programmed temperature setting or the “warm” button to increase it. After 3 seconds, the display will stop flashing and the current water temperature will again be displayed.
UNDERSTANDING OPERATING MODES Your spa controls are equipped with three operating modes to help you regulate energy consumption and reduce operating costs. How often the spa is used and the ambient temperature will help you determine which mode is best for you. To change operating modes, press the “Cool” button and while the display is still flashing, press the “light” button. The current mode will flash on the topside control.
SL Sleep Mode The water heats to 20 ̊F below the pre-programmed temperature setting The water heats during filtration cycles only “SL” is displayed on the topside controls DO NOT PUT YOUR SPA IN SLEEP MODE WHEN THE AMBIENT TEMPERATURE IS 40º F OR LOWER! Sleep Mode can significantly reduce energy consumption because the water only heats during filter cycles and stops heating when the water temperature is 20 ̊ F below the pre-programmed temperature setting.
Troubleshooting Error Messages on Topside Control Message Meaning Action Required No message to display No Power to Spa Control panel disabled until power is restored. Settings have been preserved.
Troubleshooting Error Messages on Topside Control Message Meaning HL Significant difference between sensors - likely flow problem DO NOT ENTER THE WATER! Power off GFCI, make sure slice valves locked in open position, that water level is adequate and remove debris from filter, filter basket and suction drain cover. Change filter if dirty. Power on if not resolved call 844-894-6659 for assistance.
