Use and Care Manual
For technical support and assistance, call 844-894-6659
25
Changing the Programmed Temperature Setting
To change the pre-programmed temperature setting, press the “cool” button once. The programmed water temperature will ash on the
display. While the programmed water temperature is still ashing press the “cool” button again to reduce the programmed temperature
setting or the “warm” button to increase it. After 3 seconds, the display will stop ashing and the current water temperature will again
be displayed.
The controls are in programming mode when the display is ashing. If the display is not ashing when the temperature is adjusted, the
changes will not be saved.
Freeze Protection
If the water temperature falls to 44º F, the spa will automatically turn on and will run for 4 minutes after the water
temperature reaches 46º F to prevent freezing. If your spa is in Sleep Mode when the ambient temperature is 40º F or
lower, the water temperature will likely operate in Freeze Protection Mode for extended periods if not continuously.
Setting the Filtration Cycles
Filtration cycles run every 12 hours
Continuous Filtration IS NOT RECOMMENDED
To change the length of the lter cycle, press the “Cool” button. The current water temperature will ash on the topside display.
While the temperature is still ashing, press the “Pump” button, then press the “Cool” button, stopping when the setting you want is
displayed on the topside controls. Press the “Jets” button to conrm your selection. Filter cycles can be set for 2, 4, 6, or 8 hours.
Filter continuously appears as “FC” on your topside display and should not be selected. CONTINUOUS FILTRATION CAUSES
OVERHEATING THAT WILL PERMANENTLY DAMAGE COMPONENTS. Damage from over heating is not covered under the warranty.
The rst ltration cycle will begin automatically when priming mode is complete, approximately 6 minutes after the spa is powered
on. When the ltration cycle begins, the pump will operate on high speed for approximately 1 minute to ush the lines, after which the
pump will operate on low speed until the ltration cycle is complete. Filtration cycles run every 12 hours. For example, If the GFCI is
powered on at 4:54 and you have selected 2 hour ltration cycles, your ltration cycles will run from 5 to 7 in the morning and in the
evening. If you want the ltration cycles to run from 3 to 5, you should power on the spa at 2:54.
44