Use and Care Manual

For technical support and assistance, call 844-894-6659
23
Pre-Programmed Factory Settings
The spa will start in Standard Operating Mode.
The temperature is pre-programmed to 100° F.
The minimum programmable temperature is 80º F, the maximum is 104º F
The Filtration cycle is pre-programmed to run for twice each day for two hours.
While the water is heating, the temperature is measured approximately every two minutes. After the spa has been running for 2
minutes, the current water temperature will be displayed on the topside controls. When the water temperature reaches the pre-
programmed temperature setting, the pump will automatically turn o. To display the current pre-programmed temperature setting,
press the “cool” button once. The current water temperature will ash on the display.
When the display is ashing, the spa controls are in programming mode. To prevent accidently changing pre-programmed settings, after
you press a button, you should wait 5 seconds before pressing a dierent button.
Turning the Jets On and Off
Press the “Pump” button once to turn the pump on low speed. Press the “Pump” button a second time to turn the pump on
high speed. Pressing the “Pump” button a third time will turn it o. If the “Pump” button is not pressed to turn it o manually,
the pump will shut down automatically after 20 minutes. To turn the pump back on, simply press the “Pump” button.
To ensure your safety and for optimal performance, your spa controls will automatically perform maintenance functions and run diagnostic testing.
The pump will start automatically on low speed to circulate the water every thirty minutes to run a system check. During heating, ltration and
diagnostic testing the pump runs on low speed. When the pump starts automatically to preform these actions, pressing the pump button will not
turn the pump o.
100