Use and Care Manual

For technical support and assistance, call 844-894-6659

POWERING ON YOUR SPA

After lling the spa through the lter assembly to the correct level and removing the water hose, replace the lter, the lter basket

assembly and lter cover. Turn the GFCI on. Every time the GFCI is powered on, your spa controls run diagnostic self checks.

During diagnostic testing, it is normal for a series of messages to display on your topside controls. When diagnostic self checks are

completed, the spa will start in priming mode.

Priming Mode

Each time you ll your spa, some air may be trapped in the plumbing lines. Priming mode safely removes the air. To

prevent overheating and serious damage, the heater is disabled during priming mode. Your spa starts up in priming mode

every time the GFCI is powered “ON” and ends automatically after approximately 6 minutes. When Priming Mode is

complete, the primary pump will run on low speed until the pre-set water temperature is reached.

Run Pumps to Purge the Air

When this message is displayed on your topside controls, push the “Pump ” button once to start the pump on low speed.

Press the “Pump” button a second time to switch to high speed. After conrming water is coming from all jets and the pump

is not surging, press the “Pump ” button to turn the pump o.

Within 2 minutes of pressing each pump button, water should be owing from the jets in every seat without surging. If none of the jets

in a seat work or if water surges, turn the pump o. When the water in the spa is completely still, repeat the process to initiate a second

pump priming session. If the pumps do not prime within 2 minutes on your second attempt, turn the GFCI o. Make sure the slice

valves are locked in the up position, that the diverter valves are centered for even distribution of the water, that any jet without ow is

rotated to the open position and remove any debris in the lter basket and on suction drain covers in the foot well. Power the GFCI on

and when the Priming Mode message is displayed on the topside controls, repeat the process to run each pump on HIGH SPEED. If

the pumps don’t prime on the third attempt, call 844-894-6659 for assistance.

Do not turn on any pump that will not prime. A pump that fails to prime should not be left on for more than 2 minutes under any

circumstance. The heater will engage when priming mode is complete. If a pump is not properly primed when the heater engages, the

spa may overheat causing serious damage.